Bosch Serie 6 Service Mode [TOP]

If you encounter a code you do not recognise, always or contact Bosch customer support. Blindly changing settings without knowing their meaning may cause further damage.

: Rotate the program dial directly to the 6 o'clock position (typically the Spin/Drain setting). Wait for the display panel lights to illuminate.

. You can find this information on the appliance's rating plate, usually located on the inside of the door or the back of the unit. bosch serie 6 service mode

For Bosch Serie 6 hobs, the menu (not a full service mode) can be accessed as follows:

The digital display will change instantly. If there is an active error logged in the appliance memory, it will begin flashing on the screen. If no faults are present, you will see a series of eights ( 88:88 ) or P1 . If you encounter a code you do not

Release the button. The display should show "P1" or an error code. : Turn the dial to Rinse/Spin/Drain .

| Error Code(s) | Appliance Type | Typical Meaning | Troubleshooting Step | | :--- | :--- | :--- | :--- | | E:16 | Washing Machine | The door is not closed properly or something is caught in it. | Check the door seal for obstructions and close the door firmly. | | E:17 | Washing Machine | Water tap is not turned on or water pressure is too low. | Ensure the water tap is fully open. | | E:01-00 to E:90-10 | Dishwasher | A general technical fault has occurred. | Unplug the appliance for a few minutes to reset it. | | :ƒƒ | Dishwasher | Filters are soiled or blocked. | Clean the dishwasher filters. | | Various ("µ" symbol) | Oven/Cooker | Technical fault / Electronics error. | Reset the appliance by switching off the circuit breaker for a minute. | | Not specified | Fridge-Freezer | Showroom mode is activated (appliance runs but doesn't cool properly). | Run the self-test program mentioned in Part 2.1 to exit showroom mode. | Wait for the display panel lights to illuminate

If done correctly, the LED display will change. It will either flash all lights, show --- , or display the most recent error code stored in the system memory (e.g., P1 or an E code). You are now inside the service menu. Navigating the Service Menu and Testing Components

Fixing a physical issue (like clearing a blocked drain pump filter) does not always clear the error code from the digital display. The machine may remain locked until you manually reset the module. How to Hard Reset the Memory: Enter the using the steps outlined above. Turn the program selector dial to position P1 (Fault Log).

The self-test program provides clear audio feedback: