: Access the specific calibration switch on the CPU, which often requires breaking a physical weights-and-measures wire seal.
The International Fuel Station Forum standard is widely used in Europe. It runs over a LonWorks or TCP/IP physical layer. Programming requires setting node IDs and subnet masks via the advanced communication sub-menus.
Before you modify any parameter in the SK700:
The Gilbarco Sk700 system consists of a central processing unit (CPU), a user interface, and various peripherals, such as fuel dispensers, payment terminals, and printers. The system runs on a proprietary operating system and is programmed using a specific set of commands and procedures.
Locate the processor board and move the two-wire enable jumper to the "Cold Start" position. Gilbarco Sk700 Programming Manual
The non-volatile memory backup battery may be dead or corrupted. Perform a cold master reset or replace the CPU board. Blend Ratio Out of Limits
Complete Configuration Guide for the Gilbarco Veeder-Root SK700-2 Fuel Dispenser
For blending dispensers, the high-octane and low-octane ratios (e.g., mid-grade 89 octane requiring a 65/35 split) are programmed here down to exact percentage decimals. Decimal Point and Currency Settings
: Command codes allow technicians to view non-resettable volume and monetary totals per hose. : Access the specific calibration switch on the
Defines the basic operation, currency, and volume metrics (liters/gallons). 3. Cold Start and Re-Configuration (Apollo Board)
The is the essential technical blueprint required to configure, calibrate, and troubleshoot one of the global retail fueling industry's most reliable fuel dispensers. Correct programming ensures accurate fuel delivery, seamless point-of-sale (POS) communication, and strict regulatory compliance.
If you have performed a cold start, you must re-initialize four primary parameters for the pump to function: Sets default decimals and units.
Place the dispenser into electronic calibration mode using parameter code . Programming requires setting node IDs and subnet masks
The SK700-2 Programming Parameters Guide lists several command codes for specialized settings:
Accessing basic totals, unit prices, and shifts.
The programming interface uses a code matrix to configure functions. Below is a breakdown of the most critical parameter configurations. 1. Unit Price Configuration (P02)
The dispenser lost its connection to the indoor POS. Inspect the communication wiring shield for grounding issues or check if the forecourt controller crashed.
A critical prerequisite for many programming functions is the . The dispenser's meters are calibrated in the factory before delivery. On-site calibration requires breaking a seal to open the calibration switch on either the E-Cal Board (for standard meters) or the SIP II Pulser (for meters equipped with SIP). Only one calibration switch may be opened at any one time for calibration .